Trendline Break and Retest: How to Draw and Trade It
A step-by-step guide to drawing valid trendlines, telling real breaks from fake-outs, and entering on the retest with defined stops, targets and R-multiples.
A trendline break and retest is a swing-trading setup where price closes beyond a well-drawn trendline, pulls back to touch that line from the other side, and holds. You enter on the hold, place a stop just beyond the line, and aim for a multiple of your risk. This guide shows how to draw the line, confirm the break and size the trade.
Key takeaways
- A valid trendline needs at least three touch points, a moderate slope, and a clear respect for the line by price.
- A genuine break is a daily close beyond the line, ideally with volume at least 1.5x the 50-day average, not just an intraday poke.
- The retest entry trades your risk down: the stop sits just under the old line, so risk is often smaller than on a chase entry.
- Plan every trade in R-multiples (multiples of your initial risk) and skip setups that offer less than about 2R to the first target.
- This is education, not financial advice. Patterns fail, and past performance does not guarantee future results.
How do you draw valid trendlines?
You draw a valid trendline by connecting at least two swing points, then requiring a third touch to confirm it. For a downtrend, connect lower highs. For an uptrend, connect higher lows. The line should slice through as little price action as possible.
Follow these rules:
- Use meaningful swing points. Pick clear pivot highs or lows, not every small wiggle.
- Anchor on the bodies or wicks consistently. Pick one approach and stay with it. Wicks are more common for beginners.
- Require three touches. Two points make any line. The third touch shows the market respects it.
- Space the touches out. Touches a few days apart carry less weight than touches separated by a couple of weeks.
- Keep the slope moderate. Very steep lines break easily and often mean an unsustainable move. Very flat lines are really horizontal resistance.
Treat a trendline as a zone, not a laser. Price often overshoots by a small amount, so think of a band about 0.5 times the stock's ATR (average true range, its typical daily movement) around the line.
Log vs linear scale: which should you use?
Use log (logarithmic) scale when a stock has moved more than roughly 30-50% across the line, and linear scale for tight ranges. On a linear chart, equal dollar moves look equal. On a log chart, equal percentage moves look equal.
That matters because a stock rising from $10 to $40 gains far more dollars per 10% move at the top. A linear trendline then looks steeper than the real percentage trend and can lead you to see breaks that are not there. Draw on log scale, and check that the line still looks sensible on both.
How do you spot a real break versus a fake-out?
A real break is a daily close clearly beyond the trendline, backed by above-average volume, that is not immediately reversed. A fake-out (false breakout) pokes through intraday, then closes back inside the trend.
Use these filters:
- Close, not wick. Require the daily close beyond the line, preferably by at least 1% or about 0.5 ATR.
- Volume. Aim for breakout-day volume of at least 1.5x the 50-day average. Weak volume breaks fail more often.
- Candle quality. A wide-range candle closing near its high is stronger than a small doji that barely clears the line.
- Context. A break that also clears a horizontal resistance level, or aligns with a rising market, has more going for it. See price action trading for reading these signals.
No filter eliminates fake-outs. That is why the retest, covered next, exists.
What is a descending trendline breakout?
A descending trendline breakout happens when price closes above a line drawn across a series of lower highs. It signals sellers have lost control and buyers are pushing past the supply that capped each rally.
It is the most common bullish setup for this strategy. Falling wedges often end the same way; our guide to the falling wedge pattern covers that cousin. Many traders focus on long trades only, which keeps the plan simple: wait for a descending line to break up, then look for the retest.
How do you trade the trendline break and retest step by step?
You trade it by waiting for the break, waiting for price to pull back to the old line, and entering only when the line holds as support. Patience is the edge, since many breaks never retest.
- Mark the line with at least three touches, on log scale if needed.
- Confirm the break with a daily close beyond the line and strong volume.
- Wait for the pullback. Price returns to the line, often within 3-10 trading days. Ideal retests show lighter volume than the breakout day, meaning sellers are not pressing.
- Look for a hold. A bullish candle such as a hammer, bullish engulfing or a close back above the line shows buyers defending it.
- Enter on a break above the retest candle's high, or at the close of the confirming candle.
- Place the stop and calculate size before you click.
- Set targets and manage the trade.
If price never pulls back and runs away, you miss it. That is acceptable. Chasing turns a defined-risk setup into a guess.
Where does trendline stop loss placement go?
Place the stop just below the retest low, or below the trendline by about 0.5-1 ATR, whichever is lower. This gives normal noise room while still exiting if the break is truly failing.
A stop exactly on the line is a common error because price often wicks through it. If a daily close back inside the old trend occurs, the thesis is broken.
How do you set profit targets and R-multiples?
Set the first target at the nearest prior swing high or resistance, and a second at the measured move. The measured move is the height of the prior trend range, added to the breakout point. Then divide the potential reward by your risk to get the R-multiple.
A common plan: sell a third to a half at 2R, move the stop to breakeven, and trail the rest under higher lows or the 20-day moving average. Our 20-day EMA pullback guide shows a trailing approach.
Worked example on a daily chart
All numbers here are hypothetical.
A stock falls from $60 to $42, forming lower highs at $60, $55 and $50 over two months. Connecting them gives a descending line that sits near $48 by the time of the break. Average true range is $1.40.
- Break: The stock closes at $49.50 on 2.1x its 50-day average volume. That is a close beyond the line on strong volume.
- Retest: Four days later it drifts back to $48.20 on light volume, and prints a hammer closing at $48.90.
- Entry: $49.20, above the hammer's high.
- Stop: $46.90, which is below the retest low of $47.80 minus roughly 0.65 ATR. Risk is $2.30 per share.
- Target 1: $53.50, a prior swing high. Reward is $4.30, about 1.9R.
- Target 2: $57.00, near the measured move. Reward is $7.80, about 3.4R.
With a $20,000 account risking 1% ($200), position size is $200 / $2.30, or about 86 shares. If the stop hits, the loss is about $200 or 1R. If Target 2 is reached, the gain is about 3.4R. Target 1 is just under 2R, so some traders would pass or wait for a lower-risk entry.
The setup may still fail. Ordinary losses are part of the process.
Common mistakes
- Forcing a line. Two touches or a line that cuts through candles is a guess.
- Entering on the break with no confirmation. Many fake-outs are cheap to avoid by waiting.
- Ignoring volume. A quiet break needs extra caution.
- Stops exactly on the line. Give room using ATR.
- Using linear scale on big trends. The slope misleads.
- Skipping position sizing. Risk a fixed small percentage of your account per trade.
- Redrawing the line after a failure. Moving the line to fit price is hindsight.
Beginner checklist
- Three or more touches, drawn on log scale where relevant
- Moderate slope, clean respect by price
- Daily close beyond the line by at least about 0.5 ATR
- Breakout volume at least 1.5x the 50-day average
- Retest on lighter volume, with a bullish hold candle
- Stop below the retest low with ATR buffer
- At least 2R to the first target
- Position size set to risk a fixed percentage
The bottom line
The trendline break and retest rewards patience: draw carefully, demand a decisive close, and let price come back to prove the line has flipped. Always define your stop and R-multiple first, and do your own research, since no setup works every time.
StockSetups scans US equities after the close for chart patterns built from trendline geometry and sorts long setups into lanes such as Breaking out and Retesting breakout, which can save you time finding candidates. Treat them as a starting point for your own analysis, not a recommendation.
Frequently asked questions
How long should I wait for a retest after a trendline break?
Many retests occur within about 3-10 trading days, but there is no fixed rule. If price runs away without pulling back, skip it rather than chase.
Do all trendline breakouts retest?
No. Strong breakouts often keep going without returning to the line. The retest approach trades fewer setups in exchange for better-defined risk.
Can I use trendlines on intraday charts?
Yes, the same drawing rules apply on shorter timeframes. Intraday lines are noisier, so require tighter risk control and confirmation.
What is a good minimum reward:risk for this setup?
Many swing traders look for at least 2R to the first target. Lower ratios need a very high success rate to pay off, which no setup guarantees.
Produced with AI assistance and published under the StockSetups editorial guidelines.
Get daily signals & real-time alerts.
StockSetups scans ~12,300 US stocks & ETFs after every close and sorts every long setup into four ranked lanes — each with a trade plan — plus an always-on engine firing 35+ real-time intraday alerts. Free for 7 days, no credit card.
Start free — 7-day trial, no card →Free daily signals by email. Top 3 setups per lane after every close. No account needed.
Unsubscribe anytime · Privacy